Audible Beeps & Troubleshooting
This article explains the various audible beeps and LED patterns of your VersaTile, providing you with a better understanding of your device and tips for troubleshooting.
Summary of Beeps
- Solid red light and long beep: Your “setup” mode is on. To turn it off, simply press the setup mode button and it will turn off after 2 minutes automatically.
- Short blue blink and one beep: The device is not registered on VersaHub after pressing the "Sync Now" option. For instructions on how to register your equipment, check out these videos:
- Two blue blinks and two beeps: Your device is not syncing properly. To resolve this issue, press the “Sync Now” button to reconnect your device.
- Rapid blinking of blue LED while trying to connect: Your device is trying to connect to Wi-Fi. Your device will typically connect within 15 seconds. If your device takes longer than one minute to connect, you may have a poor Wi-Fi signal.
- Blinking red light while trying to connect: There is an inactive alarm. Examine the alarm parameter settings to confirm the configuration.
- One blue blink: The device is in the process of recording data to ensure its accuracy and effectiveness.
- One red blink: Your device is recording data samples but has detected a measurement outside of the expected range. The device is not yet in alarm mode, but it is important to be aware of the issue.
- Two long red blinks followed by two long beeps, alternating red/blue, melody: Your device is able to connect and see your Wi-Fi network, but the internet is not available. Check your internet connection.
- Two long red blinks and two long beeps: Your device is unable to connect to your Wi-Fi network. This could be because your Wi-Fi password is incorrect, or because your Wi-Fi network is not within range.
- Four blue blinks and four beeps: Your device has successfully uploaded data after being set up or after the “Sync Now” button was pressed.
- Switching red and blue lights and four beeps: Your device is in WPS mode. You can put your device in WPS mode (to quickly connect to Wifi, if supported by your router) by pressing the Sync Now and the Setup Mode buttons simultaneously.
- 20 red blinks: The battery is low on your device.
